Provider-neutral self-test pilot
OVPN describes an infrastructure most providers do not claim: hardware it owns rather than rents, bare metal rather than virtual machines, and servers running with no hard drives at all because the operating system lives only in RAM. It also runs its own log-free resolvers and supports IPv6 on every server, enabled by default on new accounts. None of that is visible from a browser, which is the reason to read the lines below rather than the marketing.
Live test
OVPN turns IPv6 on by default, so an IPv6 address in the result here is expected. Read it next to the IPv4 line and see whether both name the same network.
Current-session checks
Read the signals once before connecting and once after. Because IPv6 is on by default on OVPN accounts, the interesting comparison is between the two address families rather than the presence of one.
Before you read the result
These points come from OVPN's own description of its infrastructure and from its support articles on IPv6 and DNS.
OVPN states that all its VPN servers operate without hard drives because the operating system resides only in RAM. That is a claim about what can survive a power cycle on the server side. It says nothing about what your browser hands to a website a moment later, which is the only thing measured on this page.
OVPN says all the hardware used to operate the service is owned by it, with no rented servers and no virtual machines. For a reading here that matters in one narrow way: the network your exit address belongs to should stay consistent with OVPN rather than drifting between hosting companies from one session to the next.
OVPN supports IPv4 and IPv6 on all of its VPN servers and enables IPv6 by default on accounts. An empty IPv6 line here is therefore worth a second look rather than a sigh of relief, because it may mean the device or the network you are on has no IPv6 at all rather than that the tunnel is handling it.
OVPN operates log-free DNS servers of its own to prevent DNS leaks, and its desktop client points the computer at them while connected. It also offers to set them permanently on the machine. If you took that option, a resolver naming OVPN while you are disconnected is your own earlier configuration, not a fault.
Server design is a statement about the provider. This page is a statement about one browser, on one network, in one moment. The two can disagree without either being wrong, and where they disagree the local side is nearly always the one you can act on.
Between the readings
One reading of an OVPN session describes one instant. A disconnect and a reconnect is a stretch of seconds, and anything that surfaced inside that stretch is invisible to a check that samples once.
Safe Copy exports use safe summary categories and remove raw IP, exact city, full user-agent, raw fingerprint data, raw resolver IPs and WebRTC candidates. It is not a certificate, provider audit, or proof of anonymity.
FAQ
OVPN says it supports IPv4 and IPv6 on all of its VPN servers and that IPv6 is enabled by default on accounts. That makes an IPv6 address in a reading here the documented behaviour.
Most often because the network or device you are testing from has no IPv6 of its own. The check reports what the browser could reach; it cannot tell you which link in the chain lacks the address.
It states that all hardware is owned by OVPN, that there are no rented servers or virtual machines, and that servers run without hard drives because the operating system resides in RAM.
OVPN runs its own log-free DNS servers and its desktop client points the computer at them. Which resolver actually answered for your browser is the value shown in the DNS line above.
No. Nothing reachable from a browser can confirm how a remote machine boots. A reading here confirms which network answered for you, and that is a different and smaller claim.
OVPN documents IPv6 as supported and enabled rather than something to switch off, so turning it off would remove a working path rather than close a gap. Check the provider's current guidance before changing system settings.